![]() If you require any further assistance, please do not hesitate to contact us again by writing to: Directorate of Construction - OSHA Office of Construction Standards and Compliance Assistance, Room N3621, 200 Constitution Avenue, N.W., Washington, D.C. A scaffold should never be used as an anchorage point for a fall arrest system unless it has been properly evaluated by a competent person. While the typical erected scaffold may not withstand the forces imposed by an arrested fall, with proper engineering, a scaffold can be designed so that its components are adequately braced or supported to support such loads. This Scaffold Safety Checklist is provided as a public service by the Texas. According to OSHA, every year there are 4,500 injuries and more than 60 deaths due to scaffold hazards like falls and collapse. Scaffold-related accidents and fatalities are some of the most significant in the industry. However, the 4 to 1 factor for a component required by section 1926.451(a) applies only to the load which is actually applied or transmitted to the component, not to the total load placed on the scaffold. There is a top safety hazard lurking on your construction site, and you might not even realize just how deadly it can be. You are correct that both safety factors - the two to one for the personal fall arrest system and the four to one for the scaffold components - must be maintained. Getting on and off a baker’s scaffold can be hazardous, because climbing up its end frame tends to destabilize the scaffold and may cause it to tip over. The provisions of paragraph 1926.502(d)(15) require the anchorage (i.e., the scaffold) either to be capable of supporting at least 5000 pounds, or to be designed, installed, and used as part of a complete personal fall arrest system which maintains a safety factor of at least two. Baker’s scaffolds, also known as mobile or rolling tower scaffolds, can be very dangerous if not designed, maintained, assembled, and used safely. Injured in a Fall from Scaffolding in New York Common Causes of Scaffold Accidents New York State Labor Laws Safety Requirements for Scaffolding in NY. This applies whether the scaffold is partially built (i.e., being erected or disassembled) or completely built. It is OSHA's position that scaffolding can function as a suitable anchorage for fall arrest systems when the scaffolding section so used is erected and braced such that the criteria of 1926.502(d)(15) are met. This is in response to your letter of October 31,1997, addressed to Roy Gurnham, Occupational Safety and Health Administration (OSHA), in which you highlighted the concerns using the scaffold as an anchorage point for a personal fall arrest system under. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |